The short answer
Sometimes new tile can go over old if the old is firmly bonded, level and dry, but removal is safer when there are hollow spots, damp or cracks. Inspect first: tap the tiles to find hollow areas, and check level and moisture before deciding.
How to inspect an old floor
- Tap the tiles: a hollow sound means a void beneath.
- Check level with a long straightedge.
- Look for damp stains, salts or smell.
- Note cracks running across several tiles.
- Check that a higher new floor will not clash with doors and thresholds.
When to remove the old floor
- A large share of loose or hollow tiles.
- Damp or a leak that needs waterproofing.
- A level difference a screed cannot fix.
- A full redesign of floors and bathrooms.
Preparation steps
- Remove damaged tile and clean the surface.
- Treat cracks and damp and waterproof bathrooms and kitchens.
- Level the floor and set falls.
- Choose an adhesive suited to the new tile.
- Set door thresholds and the final finished height.
Common mistakes
- Tiling over hollow tile.
- Ignoring damp and covering it.
- Changing floor level without allowing for doors.
- Not protecting furniture and cables during removal.
Ground floors in contact with the soil
On ground floors, especially in older villas and near the coast, moisture can rise from the soil into the screed beneath the tile. Signs are white salts at wall edges, joints that stay dark, or tiles lifting near walls. Covering such a floor with new tile without treating the damp moves the problem into the new tile. Moisture is therefore checked before tiling, and its source treated or a suitable system used before laying.
Levelling: thick screed or self-levelling?
- Large level differences are corrected with a cement screed of suitable thickness.
- Small differences on a sound surface may be corrected with self-levelling compound after priming.
- Levelling materials need a drying time before tiling set by the manufacturer and affected by heat.
- In bathrooms, falls to the drain are set; a dead-flat screed is not used.
Protecting the home while old tile is removed
Removal creates dust, noise and vibration. Ask for the room to be sealed off with sheeting, AC vents covered, doors and stairs protected, and suitable working hours set if the home is occupied. Pipe and cable routes in the floor are confirmed before removal so they are not damaged.
Ask for an inspection
Send photos of the old floor on WhatsApp and we will arrange an inspection to decide the best approach.
Related services: Tiles, Marble & Granite, Villa Renovation, Waterproofing & Insulation
This service in your city: Dammam, Al Khobar, Dhahran, Qatif, Jubail, Al Ahsa (Hofuf)
Frequently asked questions
How much does the floor rise when tiling over old tile?
It rises by the new tile plus the adhesive, which can be enough to obstruct doors or create a step with adjoining rooms. The finished height is measured before deciding.
Can tile be laid on a floor that is still damp?
It is not advised. Moisture weakens the adhesive and causes salts and hollow spots. Treat the source and let the surface dry, or use a system suited to damp as the inspection indicates.
How do I tell how much of the floor is hollow?
Tap the tiles with a light tool and mark the hollow-sounding areas; if they are spread across the room, removal is usually better than tiling over.