The short answer
Replacing bathroom tiles is not just laying tile; it is a chance to check plumbing and waterproofing before covering them again. The right order: removal, services and leak check, waterproofing and testing, tiling, grouting, then fittings and cleaning.
The steps
- Decide layout and sizes and choose tile and fixtures in advance.
- Remove old tile, clean the surface and locate the drain.
- Check pipework and fix any leak or old pipe before covering.
- Waterproof the floor, turn it up the walls, then flood-test.
- Set falls toward the drain and level the floor.
- Lay floor and wall tile, then grout.
- Install fixtures and accessories, then final cleaning.
Why waterproofing is not shortened
The bathroom is the most water-exposed room, and most lower-floor leaks start there. Saving a few hours on waterproofing can mean breaking tile and redoing the work later.
Details to settle early
- Wall tile height and layout pattern.
- Shower and drain position and where fixtures go.
- Details: wall niche, edges and corners.
- Ventilation and lighting.
Common mistakes
- Covering old plumbing without checking it.
- No flood test.
- Wrong falls leaving standing water.
- Ordering fixtures after starting, which delays the work.
Organising the home during a bathroom renovation
A bathroom renovation takes that bathroom out of use for a period and involves demolition that creates dust and noise. Arrange an alternative bathroom in advance, ask for corridors, doors and nearby furniture to be protected with sheeting or boards, and agree with the contractor how debris will be taken out. If the villa has several bathrooms to renovate, doing them in stages may suit the household, although doing them together can shorten the overall work time. Discuss both options before starting.
What to check yourself at handover
- Pour water on the floor and watch it run to the drain without pooling.
- Tap the tiles to make sure there are not many hollow spots.
- Straight joints of consistent width and neat corner edges.
- Sound silicone around the basin, WC and shower.
- Run the mixers and flush and check for leaks beneath them.
- Ask for the photos of the waterproofing and flood test taken during the work.
Updating a bathroom without changing everything
If the waterproofing is sound and there are no damp stains below the bathroom, sometimes replacing only the wall tile or the basins and accessories is enough. But re-tiling the floor over waterproofing of unknown condition is not advised in a bathroom above living rooms. An inspection and moisture check help choose the right scope instead of full removal or patching.
Ask for an inspection
Send photos and measurements of the bathroom on WhatsApp and we will arrange an inspection.
Related services: Tiles, Marble & Granite, Waterproofing & Insulation, Villa Renovation
This service in your city: Dammam, Al Khobar, Dhahran, Qatif, Jubail, Al Ahsa (Hofuf)
Frequently asked questions
Can new bathroom tile go over the old tile?
On walls sometimes, if the old tile is firm and flat, but on the floor it is usually not advised because it raises the level and hides the condition of the waterproofing and pipes beneath. Decide after inspection.
When should I choose mixers and accessories?
Before work starts, because outlet positions, heights and concealed mixers are fixed before waterproofing and tiling. Choosing them late is one of the most common causes of bathroom renovation delays.
Should the bathroom pipes be replaced when retiling?
Not always. If the pipes are old and corroded or there have been leaks, replacing them during the renovation costs less than breaking tile later. If they are sound, they are pressure-tested before being covered.