The short answer
A flat roof can have sound waterproofing in the middle yet leak at the drains, parapet and pipes, because those points have joints, movement and collected water. Detailing there separates a successful waterproofing job from one that keeps leaking.
Most common leak points
- Around the drain: the joint between membrane and outlet.
- Base of the parapet: membrane not turned up high enough.
- Around vent pipes and A/C bases.
- Corners and where surfaces meet.
- The membrane laps themselves.
Correct detailing
- Turn the membrane up the parapet to a suitable height, fix it and cover the top edge.
- Use a purpose-made detail around the drain, not just paint.
- Clear falls to drains with no ponding.
- Detail equipment bases instead of drilling through the membrane.
- Flood-test before covering the membrane.
Simple yearly maintenance
- Clear drains of debris before summer and the rains.
- Check membrane edges at walls.
- Watch for blisters and cracks.
- Do not place heavy or sharp objects on the membrane.
Common mistakes
- Leaving drains blocked with debris.
- Drilling through the membrane for an A/C base without repair.
- Waterproofing without turning it up the parapet.
- Falls running toward the wall, trapping water.
How to tell a drain or parapet leak from a mid-roof leak
- Where the stain is on the ceiling below: stains near external walls or under the drain usually point to the parapet or drain.
- When it appears: if it shows only after rain or washing the roof, water is entering at a point where it collects.
- The drain's condition: dust, leaves or leftover building materials around it mean water stands there for long periods.
- The membrane edge on the wall: if it is lifted, cracked or exposed to sun without a cover, it is a likely entry point.
- A partial flood test of one area at a time helps pinpoint the leak before any repair.
Dust and sun in the Eastern Province
Dust storms fill drains and corners with fine sand, and with the first rain it turns to mud that blocks the drain so water stands against the wall. Strong sun also weakens exposed membrane edges over time, so the top edge of the waterproofing on the parapet is covered with a protection layer or termination bar rather than left exposed. Clearing drains after the dust season and before the rains is one of the cheapest and most useful maintenance jobs.
AC bases and roof tanks
Installing an AC base or tank after waterproofing by piercing the layer or screwing through it is one of the most common leak causes. Ideally bases are built before waterproofing and the membrane is turned up around them with a full detail, or they sit on supports that do not penetrate the waterproofing. AC condensate should be piped to a drain rather than left to run across the roof and along the wall.
Ask for a roof inspection
Send photos of the drains and parapet on WhatsApp and we will arrange an inspection.
Related services: Waterproofing & Insulation, Building Maintenance, Refurbishment & Cleaning, Structural Shell Construction
This service in your city: Dammam, Al Khobar, Dhahran, Qatif, Jubail, Al Ahsa (Hofuf)
Frequently asked questions
Is clearing the drain enough to stop the leak?
If a blockage was trapping water, the leak may ease after clearing, but if the waterproofing around the drain is detached or cracked the leak will continue and a new drain detail is needed.
Can a parapet be fixed without redoing the whole roof?
Often yes, if the waterproofing in the middle of the roof is sound. The detail at the base of the wall and the corner is redone, the membrane turned up and covered, then flood-tested. The inspection decides.
When should I clear roof drains?
At least before the rainy season and after dust storms, and whenever you see water standing on the roof after rain.